1) During a turn Report

left rudder to be used

right rudder to be used

rudder to be maintained in centre position

2) Align light flashes during alignment (Approach Landing System) Report

fault has occurred and system needs to be turned off

It is attracting operators attention

It is indicating progress of alignment

3) During decent with power on in a helicopter Report

lift, drag and thrust are acting on the helicopter

lift, drag, thrust and weight are acting on the helicopter

lift, weight and thrust are acting on the helicopter

4) To transmit position feedback for actuators of roll and pitch control surfaces, in a fly by wire system Report

LVDT is used hence ensuring interchangeability

LVDT and RVDT are used for pitch and roll

Synchros are used

5) The compensator in a fuel tank measures Report

specific gravity of fuel

K value of fuel

fuel quantity

6) What is the error signal used for in a fixed angle approach in LOC coupling? centrifugal force Report

Heading and Deviation

Course error and Deviation

Heading ,Course error and Deviation

7) In modern aircraft, power distribution of Generators are controlled by Report

BPCU

PCDU (power control distribution unit)

SPCU

8) As you approach supersonic speed, Report

total drag is increased

Lift is reduced

Thrust is reduced

9) Range resolution is obtained by Report

High PRF

Shorter pulse width

Shorter beam width

10) In weather radar, short range targets are missed by Report

Larger pulse width

Larger beam width

Larger frequency

11) When the trailing edge flap is retracted Report

CP moves forward and the pitching moment changes to nose up

CP moves forward but the CG does not change

CP moves rearward

12) During take off if an input to auto throttle is fails Report

Auto throttle disengages

Throttle hold is annunciated

Fail light illuminates

13) Flight director command bars indicate Report

Direction in which aircraft is to be manoeuvred

Direction in which aircraft is flying

Direction in which the beacon is

14) Mode S has Report

12 address bits

24 address bits

36 address bits

15) If an aircraft is on east of VOR beacon, the reference and variable phases are Report

In phase

Opposite phase

Phase quadrature

16) In a radio altimeter system if you decide to increase the TX cable and RX cable each by 3 inch the total correction factor is Report

3 inch

6 inch

9 inch

17) If you momentarily short the two spikes of bonding tester Report

tester reads zero

tester reads full scale

tester would be zero centred

18) For bonding, the two ends of a rubber pipe are joined b Report

a thick metallic bonding strip

a corrugated bonding jumper

a wire attached by terminal legs at both ends

19) What is the minimum resistance between all isolated electrostatic conducting parts which may be subjected to appreciable charge and main earth system Report

0.5 ohm

1 ohm

0.5 Megohm or 100,000 ohm/sq.ft. surface area which ever is less

20) Mach trim in some aircraft assists Report

longitudinal stability

lateral stability

vertical stabilit

EASA Questions Module%2013 Set%205

Set 1

Set 2

Set 3

Set 4

Set 5

Set 6

Set 7

Set 8

Set 9

Set 10

Set 11

Set 12