1) What is the impedance of VOR or HF aerial cables? Report

75 ohms and 25 ohms

25 ohms

50 ohms

2) In a vibrator type voltage regulator Report

the resistor is in series with the field

parallel with the field

in series with the voltage coil

3) Where does it state what emergency equipment and what levels of emergency equipment should be carried on an aircraft Report

BCAR section A4-8 or A8-4

JAR OPS

Maintenance Manual

4) If a section of the emergency floor proximity lights are inoperative Report

the aircraft cannot fly i.e. grounded until the defect is fixed

he aircraft can fly but the section with the problem is not used/ shut off

the aircraft is allowed to fly back to base where the defect can be fixed

5) The tail nav light. What angle of divergence should it have? Report

180 degrees

120 degrees

140 degrees

6) When changing the brushes on a DC generator the brushes must be bedded first, this can be done Report

with the generator fitted to the aircraft

the generator taken off the aircraft and bedding done on the bench

at the manufacturers only

7) What must be taken into account when measuring the SG or relative density of a lead acid battery? Report

The temperature

The ambient pressure

The ambient humidity

8) The polythene coating on a HF antenna wire is provided Report

to prevent precipitation static build up

to prevent the wire from corroding

to prevent the wire from chafing

9) Weather radar domes are protected from lightning strikes by Report

the use of special conductive paint

bonding strips

special conducting or non-conducting grease

10) An elevator tab moves down Report

to counteract for the aircraft flying nose heavy

to make the nose go down

to counteract for the aircraft flying tail heavy

11) The electrolyte in a nicad battery can be checked by checking Report

one cell at a time until all cells are completed

only the end cell as all the others will be the same

any single cell as all the others will be the same

12) In a fly by wire system, pitch and roll control positions are known by using Report

LVDTs for roll control surfaces and RVDTs for pitch control surfaces

LVDTs for roll and pitch control surfaces

RVDTs for roll and pitch control surfaces

13) In a CMC aircraft, flight deck indications and warnings are managed and provided by Report

the central warning computer (CWC)

the electronic interface units (EIU)

the engine indicating and crew alert system (EICAS)

14) What type of memory do CMCs have? Report

Volatile

Non-volati

Hard

15) What is the purpose of the tail cone in helicopters? Report

To provide a balance for CofG

To hold the stabilizers and tail rotor

To provide vibration damping to the tail rotor

16) An aircraft in climb maintains the same IAS. What is it's true airspeed? Report

Higher than its IAS

Lower than its IAS

The same as its IAS

17) The stall margin is controlled by Report

EPR limits

speed bug cursor

angle of attack and flap position

18) When can the FMS be engaged with the autothrottle Report

only with the Flight Director selected

With either the Flight Director or the Digital Control System (DFCS) engaged

only after take off

19) A full authority Digital Engine Control System (FADEC) consists of Report

electronic engine control unit only

electronic engine control unit and all its sensors

electronic engine control unit and throttle position transmitter

20) A FADEC system does not have the following system? Report

An automatic starting capability

Control of thrust reverser operation

Automatic control of engine fire extinguishers

EASA Questions Module 13 Set 1

Set 1

Set 2

Set 3

Set 4

Set 5

Set 6

Set 7

Set 8

Set 9

Set 10

Set 11

Set 12