1) In case the airplane is wired for dual installation of the Central Maintenance Computers and only one computer is to be installed Report

it must be installed on LH side

it must be installed on RH side

it may be installed either on LH or RH side

2) If the static line is disconnected in the cabin, the Mach meter reading would be Report

higher mach number

lower mach number

not effected

3) In a dual FMC installation, if one FMC is defective Report

one CDU blanks

both CDU blanks

not be affected as automatic transfer takes place

4) While carrying out a leak check of the altimeter, if the static is leaking, the VSI would Report

indicate climb

indicate decent

not be affected

5) What is the authority of series actuator on an helicopters autopilot? Report

10%

50%

100%

6) In helicopter autopilots, while operating the actuator, the movement of the cockpit control is prevented by Report

synchros attached to the control

a compressed spring attached to the cockpit control

a lock on the cockpit control

7) Helicopter blades are Report

highly cambered

reverse cambered

Symmetrical

8) The cyclic stick in an helicopter is Report

to the left

to the right

in the centre

9) An autopilot computer Report

is more sensitive to ILS than to VOR

is more sensitive to VOR than to ILS

is the same sensitivity for VOR and ILS

10) What type of flap is this? Report

Split flap

Fowler flap

Plain flap

11) Purpose of the bellcrank is to Report

transmit motion

reverse direction and transmit motion

adjust friction

12) Index error is Report

coefficient B

Coefficient P

misalignment of compass lubber line

13) Helicopter derives its lift from Report

the blade of the helicopter creates a low pressure above it

rotor acts as a airscrew

air is pushed downward

14) A two bladed helicopter rotor on a central gimbal is called Report

rigid rotor

semi rigid rotor

fully articulated rotor

15) If the 'Q' feel in a powered control system fails Report

the failed system stops and it remains in this position

the pilot feels air loads higher than normal

the pilot feels air loads lower than normal

16) Servo tabs Report

enable the pilot to bring the control surface back to neutral

move in such a way as to help move the control surface

provide artificial feel

17) Spring Tabs Report

enable the pilot to bring the control surface back to neutral

move in such a way as to help move the control surface

provide artificial feel

18) Omega ground stations Report

transmit pulses of CW

carrier modulated by three audio tones

series of CW

19) When secondary stops are utilized in control surfaces, they come in contact Report

before the primary stops

after the primary stops

at the same time as the primary stops

20) EICAS indicates Report

engine performance and aircraft system malfunctions

engine performance only

engine performance and aircraft status

EASA Questions Module 13 Set 5

Set 1

Set 2

Set 3

Set 4

Set 5

Set 6

Set 7

Set 8

Set 9

Set 10

Set 11

Set 12