1) Magnetic heading errors will be Report

positive if easterly

negative if easterly

negative if northerly

2) What will happen with a flux valve in a turn? Report

It moves once the aircraft is established on a new heading

It move as the aircraft moves

It stays fixed on magnetic north

3) When will a mode C interrogation be ignored? Report

When the P2 pulse is higher amplitude to P1

When the P2 pulse is antiphase to P1

If P2 is before P1

4) A helicopter autopilot uses Report

radio altitude for height hold and barometric altitude for altitude hold

barometric altitude for height hold and radio altitude for altitude hold

barometric altitude for both height and altitude hold

5) On an ILS approach what will cause the aircraft to fly onto the beam? Report

Radio deviation

Glideslope deviation

Course deviation

6) Which of the following modes does a autopilot go through in correct sequence? Report

Flare, attitude, rollout

Attitude, flare, rollout

Rollout, attitude, flare

7) . If a helicopter rotor disc is rotating anticlockwise, viewed from above where would a pitch input be fed into the disc to move the helicopter backwards, 90 degrees to what? Report

In front of the lateral axis

Right of the longitudinal axis

Left of the longitudinal axis

8) A spring balance control system you Report

can move the control surface on the ground

can move the control surface only by moving the tab

cannot move the control surface on the ground

9) Why is a wire HF antenna covered in polythene? Report

To prevent corrosion

To prevent precipitation static

To provide lightning protection

10) If a VOR RMI indicates 000 degrees and the course selected is 000 degrees what will the TO/FROM indicator indicate? Report

TO

FROM

Neither

11) What does the Radar contour button do? Report

Alter the beam shape

Alter the transmitter power

Alter the video amplifier

12) On a helicopter, what is vortex ring state? Report

Tip vortex interference at high forward speed

Ground vortex interference when hovering close to the ground

Tip vortex build-up during hover

13) What controls are used in response to PVD display? Report

Nose wheel steering or rudder pedals

Control wheel

PVD control unit

14) DME transponder transmits on receipt Report

of any interrogation

of pilot input command request

of a pair of pulses separated by 12 microseconds

15) The best design of a MRB is where the C of P Report

does not move

moves freely along the length of the blade

is insignificant

16) The RAD alt electrical length for an helicopter is Report

16ft

12ft

28ft

17) Mode S transponders transmits a binary code of Report

12bits

64bits

24bits

18) The rotor cone is formed by Report

blade alignment

centrifugal force and lift

centrifugal force only

19) Tracking is carried out to_____________the MRB tip path Report

balance

restore

align

20) Artificial feel is gained by using a Report

hydraulic damper

spring bias unit

'feel' generator

EASA Questions Module 13 Set 5

Set 1

Set 2

Set 3

Set 4

Set 5

Set 6

Set 7

Set 8

Set 9

Set 10

Set 11

Set 12