1) On an ILS approach what will cause the aircraft to fly onto the beam? Report

Height Deviation

Radio deviation

Course deviation

2) What of the following modes does a autopilot go through in correct sequence? Report

Flare, attitude, rollout

Attitude, flare, rollout

Rollout, attitude, flare

3) When can other autopilot modes can be select once Go-Around has been selected? Report

When aircraft has reached 5000ft

When reached a desired altitude

Disengage and reengage the AFCS system

4) Forces on a helicopter in a power-on descent are Report

lift, drag thrust, weight

lift, drag, thrust

weight, drag, lift

5) What is the primary purpose of a helicopter tail arm? Report

Provide a structure for mounting the stabiliser and anti torque rotor

Acts to help balance the centre of gravity of the helicopter

Provide directional control

6) How long is the time between the start of the P1 pulse and the P3 pulse ignoring the P2 pulse length? Report

21 micro seconds

8 micro seconds

17 micro seconds

7) What does the Radar contour button do? Report

Alter the beam shape

Alter the transmitter power

Alter the video amplifier

8) A radar response takes 329 micro seconds. How far away is the target? Report

12 miles

25 miles

40 miles

9) The VHF aerial resistance and transmission line resistance is Report

50 ohms

20 ohms

20 ohms and 50 ohms respectively

10) Alert Height is when Report

a decision of whether to land is made

an alert of the altitude of the aircraft is made

an alert of the position of the aircraft is made

11) Versine is used in which channel? Report

Pitch

Roll

Yaw

12) A Master Warning is issued when Report

overspeed & low cabin altitude occurs

cargo smoke & low oil quantity occurs

engine fire & generator trip occurs

13) Which is the most important part of preventative maintenance on HIRF installations? Report

Visual inspections

Insulation testing

CMC fault indications

14) When does the pressure in the standard atmosphere halve? Report

12,000ft

5,000ft

18,000ft

15) If an aircraft is entering a turn to the left, what input would the aileron to rudder crossfeed be? Report

Left Rudder

Right Rudder

No Rudder

16) If a control surface that is fitted with a balance tab is moved, what will happen to the tab? Report

It is moved manually in the opposite direction to the surface

It is moved automatically in the same direction as the surface

It is moved automatically in the opposite direction as the surface

17) At which two points on a gas turbine engine is EPR measured? Report

Compressor inlet and jet pipe

Combustion chamber and jet pipe

Jet pipe and combustion chamber

18) If a stall is approaching, what indication does the pilot get? Report

Stick Shaker

Stick Nudger

EICAS warning

19) On a coupled approach what happens to the aircraft if it looses the localiser signal? Report

It will fly straight down the original course but will drift

It will fly in circles

It will fly on the heading the aircraft was on

20) If an autopilot is fed with radio deviation Report

it will stand off the centre line by a fixed amount

it will fly in circles

it will fly on the heading the aircraft was on

EASA Questions Module 13 Set 6

Set 1

Set 2

Set 3

Set 4

Set 5

Set 6

Set 7

Set 8

Set 9

Set 10

Set 11

Set 12