1) In what type of Doppler System do altitude holes appear? Report

FM

Pulse

FM and Pulse

2) If an aircraft moves in yaw what axis is it moving about? Report

Normal

Longitudinal

Lateral

3) The neutral shift system augments control of the Report

stabiliser

elevator

spoilers

4) On a full time Fly-by-wire system a nose up command causes Report

the two elevator surfaces on each side of the stabiliser to move up

all the elevators on each wing to move up

the two Ailerons on each wing to move up

5) What are ground spoilers used for? Report

To dump lift

To assist the aircraft coming to a stop

To slow the aircraft

6) If the aircraft is to be rolled to the right where does the pilot feed in this command? Report

Control Wheel

Control Column

Rudder Pedals

7) What is the typical aircraft hydraulic system pressure? Report

3000 psi

1000 psi

300 psi

8) If a bonding lead is found to be broken and a spare is unavailable you must Report

replace with a self manufactured cable of the same type but larger

defer the defect until correct spares are available

splice the broken lead

9) What is the bonding value between secondary structure? Report

0.5

1 ohm

Between 1Megohm and 500,000

10) What is the diagonal part of the landing gear called? Report

Drag Strut

Drag Wire

Shock Absorber

11) What is the advancing blade on a helicopter doing? Report

Increasing in lift

Going to the highest point

Increasing in drag

12) In a series actuator fitted to a helicopter how much authority does it have? Report

10% approximately

100%

50%

13) What is the output of a localiser NAV receiver? Report

Polarity sensitive AC

Polarity sensitive DC

Either

14) What does an INS calculate on power up? Report

Last Known Longitude

Last Known Latitude

Last Known Longitude & Latitude

15) If a series actuator is fitted in the cyclic control circuit of a helicopter what effect will an autopilot input have? Report

The cyclic lever will move in proportion to the autopilot input

The cyclic lever will not move

The flight director bars only will move

16) On an aircraft fitted with a CMC how do you get to the system pages? Report

Through the ground test function

Through the Existing faults function

Through the Present Leg faults function

17) What is the purpose of the autopilot trim indication? Report

The voltage activity in the servo amp

Trim tab position

Control surface position

18) What is the entry angle of an MLS installation +/-? Report

62

42

20

19) When using a bonding tester you Report

use the 6ft lead for testing different points

use the 60ft lead for testing different points

use either leads for the testing

20) What is the swash plate on a helicopter used for? Report

Control of the pitch of the rotor blades

Control of the speed of the rotor blades

Control of the flap of the rotor blades

EASA Questions Module 13 Set 6

Set 1

Set 2

Set 3

Set 4

Set 5

Set 6

Set 7

Set 8

Set 9

Set 10

Set 11

Set 12